The core unit configuration with the WinBox

Before the configuration beginning, one should reset the device to factory presets (the console command: /system reset – configuration).

After logging in on device with the Winbox, the first thing to do is to assign the IP address for Ethernet and Wireless interfaces. In order to do it, one should choose the 'IP' tab from the 'Address' menu. The next click on “+”, what enables assign IP to ours interfaces.
In case the of EoIP tunnel, the class which this tunnel works should not be agree with hand IP class. After assigning the properly address, the 'Address List' field should be appear as follows:

 


Now, we have already been creating the wireless interface configuration. At the beginnig you have to turn the wireless card ON (cause it is OFF in the default settings) by clicking on the icon of given card with right mouse button and choose the „enable” option.

Change the card settngs to 'ap bridge' work mode, select the proper frequency, channel and entry „ssid”.

We have been creating the EoIP tunnel at this moment. In order to do it, choose „+” from interface list and then „EoIP Tunnel” from avilable interfaces list.

This time we have to assign the IP address of wireless interface, placed in client unit, and the ID Tunnel identificator (the same for both side).

It is worth to remember that it might appear two identical MAC addresses in the network. Additionally, if one would like to use many tunnels for single device, one should remember that every tunnel have to have the diffrent ID Tunnel parameter. In our case it looks, as follows:

The Bridge creating.
The Ethernet port and the EoIP Tunnel have been added to the bridge by. In order to do it, choose the „Bridge” option, and then add interface by clicking „+”.

Next at the „Ports” tab, where in the already bridge created, one should add the EoIP and Ethernet ports by clicking „+”. After the ports adding the window should look like following picture: