The client unit configuration

Before the configuration beginning, one should reset the device to factory presets (the console command: /system reset – configuration).

Log in on the device with the Winbox. The first thing to do is assigning IP address to the Ethernet and Wireless interfaces. In order to do it, choose the 'IP' tab from the 'Address” menu. Clicking on “+” enables assigning the IP addresses to ours interfaces. After assigning the proper addresses, the 'Address List” field should like as follows:

We have started the wireless interface configuration. Firstly, one should turn the wireless card ON (cause it is OFF in default settings) by clicking on the given card icon with right mouse button and choosing the “enable” option.

Set the card to „station” work mode, choose the properly frequency, channel and then enter „ssid”.

The EoIP tunnel creating.
Choose „+” at the interface list and then „EoIP Tunnel” from available inteface list.

This time we have to assign the IP address of wireless interface, placed in client unit, and the ID Tunnel identificator, as the same as the previous time,however one have to change the MAC address for another one.

The Bridge creating.
The Ethernet port and the EoIP Tunnel have been added to the bridge by. In order to do it, choose the „Bridge” option, and then add interface by clicking „+”.

Next at the „Ports” tab, where in the already bridge created, one should add the EoIP and Ethernet ports by clicking „+”. After the ports adding the window should look like following picture:

Now, between the Ethernet interface of two devices the communication should be run, what is pictured below: